6 – Modules
2
LIBRARY button
Tap this button to open the effect LIBRARY Screen. (See
“Various LIBRARY Screens” on page 138.)
3
Effect type information
This shows the following information about the selected
effect type.
o
FX TYPE name
o
FX LIBRARY name (if FX LIBRARY RECALL/STORE used)
o
Block diagram of the effect input/output algorithm
4
Main parameter settings
This shows the main parameter settings of the selected
effect.
5
INPUT level meters
This shows signal levels input to the effect.
6
OUTPUT level meters
This shows the signal levels output from the effect.
7
INPUT LEVEL knob
This adjusts the levels input to the effect.
Range: - ∞ dB - +10 dB (default: 0.0 dB)
When the selection frame is shown, use the corresponding
LCD knob 1 to adjust the values.
8
Effect parameters
These show effect parameters and can be used to adjust
them.
When a selection frame is shown, use the corresponding LCD
knobs and buttons to change settings.
9
Tap tempo input buttons and tempo indicators (for
DELAY FX TYPE only)
o
Tap these buttons to set the tap intervals as the DELAY
TIME values.
o
The centers of the tap tempo buttons function as tempo
indicators, and blink at the DELAY TIME intervals. If a
DELAY TIME is “200 msec” or less, the indicator will stay
highlighted.
NOTE
Using the User Defined Control function, tap tempo input
can also be operated with USER KEY, FOOTSWITCH and GPIO-
IN controls. (See “USER DEFINED CONTROLS screen” on page
38.)
Tap tempo input is assigned as follows on the Foot Switch
and GPIO-IN pages by default.
i
Foot Switch (Tap Tempo FX3 Delay1)
i
GPIO-IN 7 (Tap Tempo FX3 Delay1)
i
GPIO-IN 8 (Tap Tempo FX4 Delay1)
0
MIX LEVEL knob
Use this to adjust the MIX levels of the dry and wet sounds.
Range: 0% (dry sound only) – 100% (default, wet sound
only)
When the selection frame is shown, use the corresponding
LCD knob 7 to adjust the value.
q
OUTPUT LEVEL knob
Use this to adjust the output level from the effect.
Range: - ∞ dB - +10 dB (default: 0.0 dB)
When the selection frame is shown, use the corresponding
LCD knob 8 to adjust the value.
Effect parameters
REVERB
Parameter name Range
default
TYPE
HALL, ROOM, STUDIO, LIVE HALL
PRE DELAY
0 msec - 200 msec
90 msec
REVERB TIME
0.1 sec - 10 sec
2.7 sec
SPREAD
0% - 100%
50%
STEREO REVERB
Parameter name Range
default
TYPE
HALL, ROOM
HALL
PRE DELAY
0 msec - 200 msec
90 msec
REVERB TIME
0.1 sec - 20.0 sec
2.7 sec
SPREAD
0% - 100%
50%
LO GAIN
-12 dB - +12 dB
0 dB
LO FREQ
125 Hz - 2.00 kHz
445 Hz
HIGH GAIN
-12 dB - +12 dB
0 dB
HIGH FREQ
1.00 kHz - 16.00 kHz
3.36 kHz
TASCAM Sonicview 16/Sonicview 24
91
