Tascam Sonicview 16, Справочное руководство

Страница: 71 / 188

5 – Routing
NOTE
The LOCK/UNLOCK button (
1
) setting is shared by the
following routing setting screens.
i
MODULE (INPUT) Screen
i
MODULE (OUTPUT) Screen
i
INPUT SOURCE SELECT Screen
i
OUTPUT PORT SELECT Screen
i
DIRECT OUT PORT SELECT Screen
i
INSERT SEND PORT SELECT Screen
i
INSERT RETURN PORT SELECT Screen
2
Input source group page switches
o
These show input source group page names.
o
Tap a page name to switch to the page with the
corresponding input source group. The name of the
selected page will be highlighted. An * will appear next to
the name of the page that the selected input source is on.
Page name Contents
ANALOG INPUT
Select analog MIC/LINE input jacks on
this page.
ST IN
Player
Select the two pairs of ST IN jacks and
the internal memory player.
Dante Select the built-in Dante inputs.
SLOT 1
Select the inputs of the expansion
card installed in SLOT 1.
SLOT 2
Select the inputs of the expansion
card installed in SLOT 2.
USB IN Select USB audio interface inputs.
3
Input source selection buttons
When the LOCK/UNLOCK button (
1
) is set to “UNLOCK”, tap
these buttons to select input sources.
The selected button will be highlighted.
Buttons that cannot be used will appear dark gray.
If a button that cannot be used is selected, it will appear dark
blue.
4
Scroll knob and scrollbar
These appear when all selectable options cannot be shown
on the display at the same time.
Drag the display to scroll the screen. The screen can also
be scrolled by swiping up and down on the input source
selection button (
2
) area as well as by turning LCD knob 8.
DIRECT OUT PORT SELECT screen
Select output ports for CH 1–40 module DIRECT OUT signals on
this screen.
Tap the OUTPUT button above the DIRECT OUT TRIM knob on
the MODULE (OVERVIEW) Screen for CH 1–40 modules to open
this screen. (See “Direct out signal output routing” on page
66.)
1
LOCK/UNLOCK button
o
This button locks/unlocks routing setting change
operations for the unit. This is always locked at the time of
start up.
o
When set to “LOCK”, tapping an output port selection
button (
3
) will not change the setting.
o
When set to “LOCK”, tap this button to open a confirmation
message. Tap the UNLOCK button to close the message
and set it to “UNLOCK”. Tapping the CANCEL button on
the confirmation message will close it and maintain the
locked state.
o
Tap this button when set to “UNLOCK” to switch it to
“LOCK”.
TASCAM Sonicview 16/Sonicview 24
71