Tascam Sonicview 16, Справочное руководство

Страница: 16 / 188

2 - Names and Functions of Parts
9
ALL SEND button ( )
Tap this button to change the SEND area display to ALL SEND
bus display.
a
These show the assignment state and send level to MIX
1–22 and FX 1–4 buses in AUX mode.
MIX 1–22 bus Shown in orange
FX 1–4 bus Shown in green
This will be gray when not assigned.
b
When the selection frame is shown, corresponding LCD
knobs can be used to adjust the SEND levels shown.
The selection frame can also be swiped up and down
to select MIX 1–22 and FX 1–4 buses.
c
These show the assignment state and send level to MIX
1–22 buses in GROUP mode. These appear but cannot
be adjusted.
OFF Shown in dark purple
ON Shown in bright purple
d
These appear light blue when the PRE/POST setting
used for MIX 1–22 and FX 1–4 buses is “PRE”.
o
Tap the ALL SEND bus area to switch to showing 4 buses
in the tapped area.
0
PAN area
o
This shows the pan/balance setting of the signals sent to
the MAIN L/R bus as well as the MAIN L/R bus assignment
status.
o
Tap this area to show the selection frame. When the
selection frame is shown, corresponding LCD knobs can
be used to adjust the pan/balance of the sent signals.
o
Tap this area while pressing the HOME key to set the
tapped pan/balance setting to center (C). (See “12 – List of
shortcut operations” on page 168.)
o
When the selection frame is shown, tap this area to open
the MODULE (SEND/ PAN) Screen. (See “MODULE (SEND/
PAN) Screen” on page 102.)
q
NAME area
o
The module name is shown at the top left.
o
At the top right, the Mute Group assignment status is
shown in the top line and the DCA assignment status
is shown in the bottom line. Red numbers show the
assigned Mute Group numbers. Yellow numbers show the
assigned DCA numbers.
See “Mute Group Assign page” on page 121 and
“MODULE (OVERVIEW) Screen” on page 78 for changing
Mute Group assignments.
See “DCA Assign page” on page 120 and “MODULE
(OVERVIEW) Screen” on page 78 for changing DCA
assignments.
o
The bottom line shows the user module name (name set
by user). If the name has not been defined, the module
name will be shown as “CH 1”, for example. See “Setting
and editing user module names” on page 123 for details
about setting user module names.
o
The NAME area background color is the color set for the
assigned module. See “Changing set module colors” on
page 125 to change set module colors.
o
Tap this area to open the MODULE (OVERVIEW) Screen.
(See “MODULE (OVERVIEW) Screen” on page 78.)
16
TASCAM Sonicview 16/Sonicview 24