4 – Mixer configuration and settings
GPIO-OUT page
On this page, functions can be assigned to the GPIO output
connector of this unit or of an SB-16D connected through the
built-in Dante.
Tap Menu Screen > Rear Panel Setup > GPIO Output Setup to
open this page.
GPIO-OUT page when setting controls
The factory default settings are as follows.
Port number
Assigned function
1
Fader Start/Stop CH29
2
Fader Start/Stop CH31
3
Fader Start/Stop CH33
4
Fader Start/Stop CH35
5
Fader Start/Stop CH37
6
Fader Start/Stop CH39
7
Fader Start/Stop STIN1
8
Fader Start/Stop STIN2
Fader Start Level setting
This sets the trigger level of the fader start/stop function
(default: -60 dB).
1. Tap the
button on the USER DEFINED CONTROLS Screen
to open a settings window.
2. Tap the setting level value of the Fader Start Level item in
the window to change its appearance as shown below. The
Channel Screens also switch to showing fader start setting.
3. Adjust the channel faders on the right top panel to the
desired start/stop trigger levels.
The adjusted values are shown in the window.
4. Tap the APPLY button to set the fader start level to the
position of the corresponding fader, closing the window
and returning to normal display.
Tap the CANCEL button to close the window and return to
normal display.
TASCAM Sonicview 16/Sonicview 24
45
