Shihlin SA3 Series, Руководство пользователя

Страница: 377 / 423

Appendix 1 Parameter table
APPENDIX 375
Group
Parameter
Number
Name Setting Range Default Page
05-39 P.395 Second motor load inertia ratio
0～600.0
99999 179
99999
06-00 P.9
Electronic thermal relay
capacity
0~500.00A: Below frame G Accordin
g to
frame
184
0~5000.0A: Frame G and above
06-01 P.22 Stall prevention operation level 0～250.0% 150.0% 185
06-02 P.23
Stall prevention operation level
correction factor
0～150.0%
99999 185 99999: Stall prevention operation level is the setting
value of 06-01(P.22).
06-03 P.66
Stall prevention operation
reduction starting frequency
50Hz system: 0～650.00Hz 50.00Hz
185
60Hz system: 0～650.00Hz 60.00Hz
06-04 P.220
Acceleration and deceleration
time when current stall
0: According to the current Acc/Dec time
3 185
1: According to the first Acc/Dec time
2: According to the second Acc/Dec time
3: Automatically calculate proper
Acc/Dec time
06-05 P.30 Regenerative brake selection
0: Brake duty is fixed at 3%, parameter 06-06(P.70)
will be off.
0
186
1: Brake duty is 06-06(P.70) value.
2：Connect to brake unit（D frame and above）
2
06-06 P.70
Special regenerative brake
duty
0～100.0% 0.0% 186
06-07 P.263
Decrease carrier protection
setting
0: Fixed carrier frequency, and limit output current
according to carrier value.
0 187
1: Fixed rated current, and limit carrier according to
output current and temperature.
06-08 P.155 Over torque detection level 0～200.0% 0.0% 189
06-09 P.156 Over torque detection time 0.1～60.0s 1.0s 189
06-10 P.260 Action when detect over torque
0: OL2 alarm will not be reported after over torque
detection, and inverter keeps running.
1 189
1: OL2 alarm will be reported after over torque
detection, and inverter stops.
06-11 P.160 Stall level when restart 0～150.0% 100.0% 189
06-12 P.245 Cooling fan operation
0X: Inverter shows FAN alarm when fan is damaged.
0 190
1X: Inverter don’t alarm when fan is damaged, but
the output terminal which is set to function 16
will output a signal.
X0: Fan turn on when inverter starts running. Fan
turn off 30 seconds after inverter stops.
X1: Fan turn on when inverter power on. Fan turn off
when inverter power off.
X2: Fan turn on if heat sink temperature is higher
than 40℃. Fan turn off when inverter power off.
X3: Fan turn on if heat sink temperature is higher
than 60℃. Fan turn off when heat sink
temperature is lower than 40℃.