Shihlin SA3 Series, Руководство пользователя, Страница: 393 / 423

Appendix 1 Parameter table
APPENDIX 391
Group
Parameter
Number
Name Setting Range Default Page
14-00 P.600 Tension control parameter
0：Off
0 297
1：Open loop torque control mode（under
closed
loop vector control mode）
2：Closed loop speed control mode
3：Closed loop torque control mode（under
closed
loop vector control mode）
4：Constant linear speed control mode
14-01 P.601 Rolling mode
0：Wind roll
0 297
1：Release roll
14-02 P.602
Tightening roll option
when releasing 0：Forbid tightening material during startup
0 297
1：Allow tightening material during startup
14-03 P.603 Mechanical transmission ratio 0～300.00 1.00 297
14-04 P.604 Tension setting source
0：Parameter 14-05（P.605）setting
0 298 1：Analog value or PULSE input setting
2：Communication setting
14-05 P.605 Tension setting 0～30000N 0N 298
14-06 P.606 Maximum tension 0～30000N 0N 298
14-07 P.607 Zero-speed tension increase 0～50.0% 0.0% 298
14-08 P.608 Zero-speed threshold 0～30.00Hz 0.00Hz 298
14-09 P.609 Tension taper 0～100.0% 0% 298
14-10 P.654 Taper compension correction value 0～10000mm 0mm 298
14-11 P.610
Winding radius calculation method
options
0：Calculate by linear speed
0 299
1：Calculate by thickness(encoder of motor
side)，pulse signal connects to A1/B1 of
PG card
2：Calculate by thickness (encoder of winding
shaft)，pulse signal input to terminal HDI
3：Analog value of pulse input
14-12 P.650
Calculate winding memory control by
thickness calculation
0：Do not save winding radius when power
outage or calculation stops
0 300
1：Save winding radius when there’s a power
outage or calculation stops ， and use
saved winding radius as initial winding
radius when power recovers or calculation
restarts
14-13 P.611 Maximum winding radius 1～10000mm 500mm 300
14-14 P.612 Winding diameter 1～10000mm 100mm 300
14-15 P.613 Initial winding radius source
0：Initial winding radius is determined by
parameter 14-16(P.614)～14-18(P.616)
0 300
1：Initial winding radius is determined by
analog value