Shihlin SA3 Series, Руководство пользователя

Страница: 350 / 423

Appendix 1 Parameter table
APPENDIX 348
Parameter
Number
Group Name Setting Range Default Page
P.594 02-57 PT100 thermistor level 1 frequency 0～650.00Hz 0.00Hz 138
P.595 02-58 PT100 thermistor level 1 delay time 0～6000s 60s 138
P.600 14-00 Tension control parameter
0：Off
0 297
1：Open loop torque control mode（under closed
loop vector control mode）
2：Closed loop speed control mode
3：Closed loop torque control mode（under closed
loop vector control mode）
4：Constant linear speed control mode
P.601 14-01 Rolling mode
0：Wind roll
0 297
1：Release roll
P.602 14-02
Tightening roll option when
releasing
0：Forbid tightening material during startup
0 297
1：Allow tightening material during startup
P.603 14-03 Mechanical transmission ratio 0～300.00 1.00 297
P.604 14-04 Tension setting source
0：Parameter 14-05（P.605）setting
0 298 1：Analog value or PULSE input setting
2：Communication setting
P.605 14-05 Tension setting 0～30000N 0N 298
P.606 14-06 Maximum tension 0～30000N 0N 298
P.607 14-07 Zero-speed tension increase 0～50.0% 0.0% 298
P.608 14-08 Zero-speed threshold 0～30.00Hz 0.00Hz 298
P.609 14-09 Tension taper 0～100.0% 0% 298
P.610 14-11
Winding radius calculation method
options
0：Calculate by linear speed
0 299
1：Calculate by thickness(encoder of motor side)，
pulse signal connects to A1/B1 of PG card
2：Calculate by thickness (encoder of winding
shaft)，pulse signal input to terminal HDI
3：Analog value of pulse input
P.611 14-13 Maximum winding radius 1～10000mm 500mm 300
P.612 14-14 Winding diameter 1～10000mm 100mm 300
P.613 14-15 Initial winding radius source
0：Initial winding radius is determined by parameter
14-16(P.614)～14-18(P.616)
0 300
1：Initial winding radius is determined by analog
value
P.614 14-16 Initial winding radius 1 1～10000mm 100mm 300
P.615 14-17 Initial winding radius 2 1～10000mm 100mm 300
P.616 14-18 Initial winding radius 3 1～10000mm 100mm 300
P.617 14-19 Winding radius filter time 0～1000ms 0ms 300
P.618 14-20 Current winding radius 0～10000mm 0mm 300
P.619 14-21 Pulse per cycle 1～60000 1 300
P.620 14-22 Cycle per layer 1～10000 1 300