Shihlin SA3 Series, Руководство пользователя

Страница: 388 / 423

Appendix 1 Parameter table
APPENDIX 386
Group
Parameter
Number
Name Setting Range Default Page
10-34 P.274
When input power fail subtracted
frequency at
deceleration start
0～20.00Hz 3.00Hz 264
10-35 P.275
When input power fail subtraction
starting frequency
0～120.00Hz: When output frequency≥
10-35(P.275), Motor decelerates from “output
frequency - 10-34(P.274)”；When output
frequency＜10-35(P.275), deceleration from
output frequency
50.00Hz 264
99999: Motor decelerates from “output frequency
- 10-34(P.274)”
10-36 P.276
Deceleration time during input
power failure 1
0~360.00s/0~3600.0s
5.00s 264
10-37 P.277
Deceleration time during input
power failure 2
0~360.00s//0~3600.0s: Set deceleration time
below the set frequency of 10-38 (P.278)
99999 264
99999: Set deceleration time to the set frequency
of 10-38 (P.278)
10-38 P.278
When input power fail
deceleration time
switch-over frequency
0～650.00Hz 50.00Hz 264
10-39 P.279 UV avoidance voltage gain 0～200.0% 100.0% 264
10-40 P.700 VF separated voltage source
0: Given by digital 10-41(P.701).
0 265
1: Given by analog or HDI pulse signal.
10-41 P.701 VF separated voltage digital 0～440.00V/0~220.00V
According
to voltage
265
10-42 P.702 VF separated voltage Acc time 0～1000.0s 0.0s 265
10-43 P.703 VF separated voltage Dec time 0～1000.0s 0.0s 265
10-44 P.704 VF separated stop selection
0: Frequency/voltage independently decreases to
0.
0 265
1: After the voltage decreases to 0, frequency
decreases.
10-45 P.267
Regeneration avoid function
selection
0: Off.
0 266
1:Regeneration avoid function is always on.
(Automatic calculate Acc/Dec speed )
2: Regeneration avoid function is on only during
constant speed operation (Automatic calculate
Acc/Dec speed )
10-45 P.267
Regeneration avoid function
selection
11: Regeneration avoid function is always on.
(Manual mode, Acc/Dec speed is set by
10-49(P.271) and 10-50(P.272))
0 266
12: Regeneration avoid function is on only during
constant speed operation (Manual mode,
Acc/Dec speed is set by 10-49(P.271) and
10-50(P.272))