Shihlin SA3 Series, Руководство пользователя

Страница: 250 / 423

Application parameter group 10
PARAMETER DESCRIPTION 248
Group
Parameter
Number
Name Setting Range Default Page
10-45 P.267
Regeneration avoid function
selection
11: Regeneration avoid function is always on.
(Manual mode, Acc/Dec speed is set by
10-49(P.271) and 10-50(P.272))
0 266
12: Regeneration avoid function is on only during
constant speed operation (Manual mode,
Acc/Dec speed is set by 10-49(P.271) and
10-50(P.272))
10-46 P.268
Regeneration avoid action
voltage level 220V : 155～400V 380V 267
440V : 310～800V 760V 267
10-47 P.269
Regeneration avoid function
DC bus voltage detection
sensitivity at deceleration
0: Prevent regeneration avoidance from failing
according to bus voltage change rate
0 267
1～5: Set the sensitivity to detect the bus voltage
change rate. Larger number, higher sensitivity.
10-48 P.270
Regeneration avoid
frequency compensation
value 0～10.00Hz: Set the limit value of regenerative
avoid frequency compensation.
6.00Hz 267
99999: Off.
10-49 P.271
Regeneration avoid
voltage gain coefficient
0～400.0%/0～40.0% 100.0% 267
10-50 P.272
Regeneration avoid
frequency gain coefficient
0～400.0%/0～40.0% 100.0% 267
10-51 P.264 Over excitation deceleration
0: Off.
0 267
1: Over excitation deceleration is valid.
10-52 P.265 Over excitation current level 0～200.0% 150.0% 267
10-53 P.266 Over excitation gain 1.00～1.40 1.10 267
10-54 P.362
Short-circuit brake time when
PM motor start
0~60.0s 0.0s 268
10-55 P.780 PLC function selection
0: Off
0
268
1: PLC RUN signal from digital input terminal
function 60 or 10-56 (P.781)。
2： PLC RUN signal from digital input terminal
function 60
10-56 P.781 PLC run
0: Off
0
268
1: PLC RUN
10-57 P.782 PLC program erase function
0: Off
0
268
1: Erase the PLC program, after erase success
parameter value is 0.
10-58
P.783
PLC choose register to
monitor
0~326 0
268
10-59 P.784
PLC register monitoring
value
Read only
Read
only
268