IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 226 / 264

4. If an expansion enclosure is installed, remove it (see “Removing an expansion
enclosure from a system-board tray” on page 131); otherwise, remove the
system-board tray cover (see “Removing the system-board tray cover” on page
125).
5. Remove the hard disk drives, if any are installed (see “Removing and installing
a hard disk drive” on page 139).
6. Remove the hard disk drive bracket and cable assembly (see “Removing and
installing a one-bay or four-bay hard disk drive bracket and cable assembly” on
page 168).
7. Remove the 2.5-inch SAS/SATA drive cage, if one is installed (see “Removing
a 2.5-inch SAS/SATA drive cage” on page 147).
8. Remove the mini-SAS RAID controller and PCIe adapters, if any are installed
(see “Removing an adapter from the system-board tray” on page 152).
9. Remove the riser card (see “Removing a PCIe riser-card assembly from the
system-board tray” on page 171).
10. Remove the battery from the system board (see “Removing the battery” on
page 137).
11. Remove the DIMMs (see “Removing a memory module” on page 163).
12. Remove the microprocessors and heat sinks (see “Removing a microprocessor
and heat sink” on page 197).
13. If you are instructed to return the system-board tray, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Note: Remove the shipping brackets from the replacement system-board tray
and install them on the system-board tray you are returning.
Installing the system-board tray
Note: When you replace the system-board tray, you must either update the
system-board tray with the latest firmware or restore the pre-existing
firmware that the customer provides on a diskette or CD image. Make sure
that you have the latest firmware or a copy of the pre-existing firmware
before you proceed. See “Firmware updates” on page 213, “Updating the
Universal Unique Identifier (UUID)” on page 227, and “Updating the
DMI/SMBIOS data” on page 229 for more information.
Important: Some cluster solutions require specific code levels or coordinated code
updates. If the device is part of a cluster solution, verify that the latest
level of code is supported for the cluster solution before you update the
code.
To install a system-board tray, complete the following steps.
210
System x iDataPlex dx360 M2: Problem Determination and Service Guide