IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 178 / 264

Installing an IBM virtual media key
To install an IBM virtual media key, complete the following steps.
1. Align the virtual media key with the connector.
2. Press on the virtual media key until it is firmly seated in the connector and make
sure that the retention clip engages the virtual media key.
3. Install the expansion enclosure, if you removed one (see “Installing an
expansion enclosure on a system-board tray” on page 132); otherwise, install
the system-board tray cover (see “Installing the system-board tray cover” on
page 125).
4. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 127 or “Installing the system-board tray in a 3U
chassis” on page 129).
Removing an I
2
C multiplexer card
To remove a multiplexer card from the I/O enclosure, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 123.
2. If the system-board tray is installed in a chassis, remove it (see “Removing the
system-board tray from a 2U chassis” on page 126).
162
System x iDataPlex dx360 M2: Problem Determination and Service Guide