IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 219 / 264

Note: If the grease is correctly applied, approximately half of the grease will
remain in the syringe.
6. Install the heat sink onto the microprocessor as described in “Installing a
microprocessor and heat sink” on page 199.
Removing a PCIe riser-card assembly from the I/O enclosure
To remove a PCIe riser-card assembly from the I/O enclosure, complete the
following steps.
I/O enclosure
Two-slot
riser card
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 123.
2. If the system-board tray is installed in a chassis, remove it (see “Removing the
system-board tray from a 2U chassis” on page 126).
3. Remove the I/O enclosure from the system-board tray (see “Removing an
expansion enclosure from a system-board tray” on page 131).
4. Carefully set the I/O enclosure on a flat, static-protective surface.
5. Remove the PCIe adapter bay cover from the I/O enclosure and save it for
future use (see “Removing the PCIe adapter bay cover” on page 143).
6. Remove the PCIe adapter, if one is installed, and save it for future use (see
“Removing an adapter from the I/O enclosure” on page 151).
7. Remove the four screws that secure the PCIe riser-card assembly to the I/O
enclosure and save them for future use.
8. Pull the PCIe riser-card assembly off the mounting studs and out of the I/O
enclosure.
9. If you are instructed to return the PCIe riser-card assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing a PCIe riser-card assembly in the I/O enclosure
To install a PCIe riser-card assembly in the I/O enclosure, complete the following
steps.
Chapter 5. Removing and replacing server components
203