IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 158 / 264

Removing a 3.5-inch simple-swap hard disk drive
To remove a 3.5-inch simple-swap hard disk drive, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 123.
2. If the system-board tray is operating, shut down the operating system; then,
press the power-control button to turn off the system-board tray (see “Turning
off the system-board tray” on page 10 for more information).
3. Remove the filler panel from the drive bay.
4. Pull the loops of the drive toward each other; then, pull the drive out of the drive
bay.
5. If you are instructed to return the hard disk drive, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Installing a 3.5-inch simple-swap hard disk drive
To install a 3.5-inch simple-swap hard disk drive, complete the following steps.
142
System x iDataPlex dx360 M2: Problem Determination and Service Guide