IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 213 / 264

Power supply
paddle card
PCIe adapter
PCIe adapter
bay cover
Two-slot
riser card
2x2 2.5-inch
filler panels
3.5-inch simple-swap
hard disk drive
Hard disk drive
bracket and
cable assembly
I/O enclosure
3.5-inch filler
panel
1. Install the PCIe riser-card assembly (see “Installing a PCIe riser-card assembly
in the I/O enclosure” on page 203).
2. Install the PCIe adapters, if you removed any (see “Installing an adapter in the
I/O enclosure” on page 152).
3. Install the power-supply paddle card, if you removed one (see “Installing a
power-supply paddle card in an expansion enclosure” on page 179).
4. Install the hard disk drive bracket and cable assembly (see “Removing and
installing a one-bay or four-bay hard disk drive bracket and cable assembly” on
page 168).
5. Install the hard disk drive, if you removed one (see “Removing and installing a
hard disk drive” on page 139).
6. Install the I/O enclosure on the system-board tray (see “Installing an expansion
enclosure on a system-board tray” on page 132).
Removing a microprocessor and heat sink
Read the following important guidelines before you remove a microprocessor that is
not faulty (for example, when you are replacing the system-board assembly).
If you are not replacing a defective heat sink or microprocessor, the thermal
material on the heat sink and microprocessor will remain effective if you observe
the following precautions:
v
Carefully handle the heat sink and microprocessor when you remove or install
these components.
v
Do not touch the thermal material or otherwise allow it to become contaminated.
Chapter 5. Removing and replacing server components
197