IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 187 / 264

8. If you are instructed to return the hard disk drive bracket and cable assembly,
follow all packaging instructions, and use any packaging materials for shipping
that are supplied to you.
Installing a four-bay hard disk drive bracket and cable assembly
To install a four-bay hard disk drive bracket and cable assembly in the storage
enclosure, complete the following steps.
Storage
enclosure
Hard disk drive bracket
and cable assembly
Release latch
Release latch
1. Touch the static-protective package that contains the hard disk drive bracket
and cable assembly to any unpainted metal surface on the outside of the
storage enclosure; then, remove the hard disk drive bracket and cable assembly
from the package.
2. Place the hard disk drive bracket and cable assembly on the mounting tabs
inside the storage enclosure; then, press down on the hard disk drive bracket
and cable assembly until the release latches click into place.
3. Reconnect the hard disk drive bracket and cable assembly cables.
4. Install the hard disk drives, if you removed any from the storage enclosure (see
“Installing a 3.5-inch simple-swap hard disk drive” on page 142).
5. Install the storage enclosure (see “Installing an expansion enclosure on a
system-board tray” on page 132).
6. Install the system-board tray in the chassis (see “Installing the system-board
tray in a 2U chassis” on page 127).
Removing a PCIe riser-card assembly from the system-board tray
To remove a PCIe riser-card assembly from the system-board tray, complete the
following steps.
Chapter 5. Removing and replacing server components
171