IBM System x iDataPlex dx360 M2, Руководство по диагностике и обслуживанию

Страница: 163 / 264

Removing a 2.5-inch SAS/SATA drive cage
To remove a 2.5-inch SAS/SATA drive cage, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 123.
2. If hard disk drives are installed in the 2.5-inch SAS/SATA drive cage that you
plan to remove, make a note of where the drives are installed; then, remove
them (see “Removing a 2.5-inch hot-swap hard disk drive” on page 139).
3. If the system-board tray is installed in a chassis, remove it (see “Removing the
system-board tray from a 2U chassis” on page 126).
4. If the 2.5-inch SAS/SATA drive cage is installed in an expansion enclosure drive
bay, complete the following steps:
a. Make a note of where the cables are attached; then, remove them.
b. Pull up on the release lever at the top of the drive bay; then, grasp the
2.5-inch SAS/SATA drive cage and pull it out of the front of the drive bay.
5. If the 2.5-inch SAS/SATA drive cage is installed in the system-board tray drive
bay, complete the following steps:
a. If an expansion enclosure is installed, remove it (see “Removing an
expansion enclosure from a system-board tray” on page 131); otherwise,
remove the system-board tray cover (see “Removing the system-board tray
cover” on page 125).
b. Make a note of where the cables are attached; then, remove them.
c. Pull up on the release lever at the top of the drive bay; then, grasp the
2.5-inch SAS/SATA drive cage and pull it out of the front of the drive bay.
6. If you are instructed to return the 2.5-inch SAS/SATA drive cage, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
Chapter 5. Removing and replacing server components
147