IBM 7383, Инструкция по установке и обслуживанию

Страница: 411 / 488

Table 38. DSA messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
If an action step is preceded by “(Trained technician only)”, that step must be performed only by a trained
technician.
v Go to the IBM support website at http://www.ibm.com/supportportal to check for technical information, hints,
tips, and new device drivers or to submit a request for information.
Message
number
Component Test State Description Action
264-906-000 Tape Drive Tape Drive
Test Failed Unrecognized
error.
1. Clean the tape drive using the
appropriate cleaning media and
install new media.
2. Run the test again.
3. Clear the error log.
4. Run the test again.
5. Make sure that the firmware is at the
latest level. Software for tape drives
and libraries can be found at IBM
website.
6. Run the test again.
7. If the failure remains, go to the IBM
website for more troubleshooting
information.
405-901-xxx Ethernet
Device Test Control
Registers Failed
1.
Make sure that the component
firmware is at the latest level. The
installed firmware level is shown in
the DSA event log in the
Firmware/VPD section for this
component.
2. Run the test again.
3. Replace the component that is
causing the error. If the error is
caused by an adapter, replace the
adapter. Check the PCI Information
and Network Settings information in
the DSA event log to determine the
physical location of the failing
component.
4. If the failure remains, go to the IBM
website for more troubleshooting
information.
Appendix B. DSA messages
393