IBM 7383, Инструкция по установке и обслуживанию, Страница: 377 / 488

Table 37. UEFI/POST diagnostic codes (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
If an action step is preceded by “(Trained technician only)”, that step must be performed only by a trained
technician.
v Go to the IBM support website at http://www.ibm.com/supportportal to check for technical information, hints,
tips, and new device drivers or to submit a request for information.
Diagnostic
code
Message Description Action
I.3818002 [I.3818002] The
firmware image
capsule signature
for the non-booted
flash bank is
invalid. Opposite Bank
CRTM Capsule
Update
Signature
Invalid.
1. Run the Setup utility, select Load Default Settings , and
save the settings.
2.
Recover the server firmware (see Recovering the server
firmware).
3. If error does not persist, no additional recovery action is
required.
4. If error persists, or boot is unsuccessful, (trained technician
only) replace the system board (see Removing the system
board and Installing the system board).
I.3818003 [I.3818003] The
CRTM flash driver
could not lock the
secure flash region. CRTM Could
not lock secure
flash region.
1. Continue booting system. If system does not reset,
manually reset the system.
2. If the error is not reported on the subsequent boot, no
additional recovery action is required.
3.
If the error persists, continue booting system and refresh
UEFI image.
4. (Trained technician only) Replace the system board (see
Removing the system board and Installing the system
board).
S.3818004 [S.3818004] The
CRTM flash driver
could not
successfully flash
the staging area. A
failure occurred. CRTM Update
Failed.
1. Continue booting system. If system does not reset,
manually reset the system.
2. If the error is not reported on the subsequent boot, no
additional recovery action is required.
3. If the error persists, continue booting system and refresh
UEFI image.
4.
(Trained technician only) Replace the system board (see
Removing the system board and Installing the system
board).
W.3818005 [W.3818005] The
CRTM flash driver
could not
successfully flash
the staging area.
The update was
aborted. CRTM Update
Aborted.
1. Continue booting system. If system does not reset,
manually reset the system.
2. If the error is not reported on the subsequent boot, no
additional recovery action is required.
3. If the error persists, continue booting system and refresh
UEFI image.
4. (Trained technician only) Replace the system board (see
Removing the system board and Installing the system
board).
Appendix A. UEFI/POST error codes
359