IBM 7383, Инструкция по установке и обслуживанию

Страница: 371 / 488

Table 37. UEFI/POST diagnostic codes (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
If an action step is preceded by “(Trained technician only)”, that step must be performed only by a trained
technician.
v Go to the IBM support website at http://www.ibm.com/supportportal to check for technical information, hints,
tips, and new device drivers or to submit a request for information.
Diagnostic
code
Message Description Action
S.680B9 [S.680B9] External
QPI Link Failure
Detected. External QPI
Link Failure
Detected.
1. Check the IBM support website for an applicable retain tip
or firmware update that applies to this error.
2.
Inspect the microprocessor socket for foreign material, if
the microprocessor socket contains any foreign material,
remove the foreign material. If it is found damaged,
(trained technician only) replace the system board (see
Removing the system board and Installing the system
board) or the microprocessor 2 expansion board (see
Removing the microprocessor 2 expansion board and
Installing the microprocessor 2 expansion board).
3. Make sure the microprocessor 2 expansion board is
installed correctly (see Installing the microprocessor 2
expansion board).
4.
(Trained technician only) Reseat the microprocessor (see
Removing a microprocessor and heat sink and Installing a
microprocessor and heat sink).
5.
(Trained technician only) Replace the microprocessor (see
Removing a microprocessor and heat sink and Installing a
microprocessor and heat sink).
S.2011001 [S.2011001] An
Uncorrected PCIe
Error has Occurred
at Bus % Device %
Function %. The
Vendor ID for the
device is % and the
Device ID is %. PCI SERR
Detected.
1. Check the PCI LEDs.
2. Reseat all affected adapters and the PCI-X interposer card.
3. Update the PCI adapter firmware.
4. Replace the affected adapters (see Removing an adapter
and Installing an adapter).
5. (Trained technician only) Replace the system board (see
Removing the system board and Installing the system
board).
S.2018001 [S.2018001] An
Uncorrected PCIe
Error has Occurred
at Bus % Device %
Function %. The
Vendor ID for the
device is % and the
Device ID is %. PCIe
Uncorrected
Error Detected.
1.
Check the PCI LEDs.
2.
Reseat all affected adapters and the PCI-X interposer card.
3. Update the PCI adapter firmware.
4. Replace the affected adapters and (see Removing an
adapter and Installing an adapter).
5. (Trained technician only) Replace the system board (see
Removing the system board and Installing the system
board).
Appendix A. UEFI/POST error codes
353