IBM 7383, Инструкция по установке и обслуживанию

Страница: 283 / 488

CAUTION:
When replacing the lithium battery, use only IBM Part Number 33F8354 or an
equivalent type battery recommended by the manufacturer. If your system has a
module containing a lithium battery, replace it only with the same module type
made by the same manufacturer. The battery contains lithium and can explode if
not properly used, handled, or disposed of.
Do not:
v
Throw or immerse into water
v Heat to more than 100°C (212°F)
v
Repair or disassemble
About this task
To install the replacement battery, complete the following steps.
Procedure
1. Follow any special handling and installation instructions that come with the
replacement battery.
2.
Insert the new battery:
a. Tilt the battery so that you can insert it into the socket on the side opposite
the battery clip.
b.
Press the battery down into the socket until it clicks into place. Make sure
that the battery clip holds the battery securely.
c. If you removed a rubber cover from the battery holder, use your fingers to
install the battery cover on top of the battery connector.
3. Install and lock the left-side cover (see “Installing the left-side cover” on page
205).
4. Reconnect the external cables and power cords; then, turn on the attached
devices and turn on the server.
Note:
You must wait approximately 3 minutes after you connect the server
power cord to an electrical outlet before the power-control button becomes
active.
5. Start the Setup utility and reset the configuration:
Chapter 6. Removing and replacing components
265