IBM 7383, Инструкция по установке и обслуживанию

Страница: 245 / 488

7. Rotate the drive tray handle to the closed position.
8.
Check the hard disk drive status indicator to make sure that the hard disk
drive is operating correctly. After you replace a failed hard disk drive, the
green activity LED flashes as the disk spins up. The yellow LED turns off after
approximately 1 minute. If the new drive starts to rebuild, the yellow LED
flashes slowly, and the green activity LED remains lit during the rebuild
process. If the yellow LED remains lit, see the “Hard disk drive problems” on
page 153 for more information.
Note: You might have to reconfigure the disk arrays after you install hard
disk drives. See the RAID documentation on the IBM website at
http://www.ibm.com/supportportal for information about RAID adapters.
9.
Close the bezel (see “Closing the bezel media door” on page 185).
10. Lock the left-side cover.
Removing a 3.5-inch simple-swap hard disk drive
Use this information to remove a 3.5-inch simple-swap hard disk drive.
Before you begin
Attention: To maintain proper system cooling, do not operate the server for more
than 10 minutes without either a drive or a filler panel installed in each drive bay.
Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To remove a 3.5-inch simple-swap hard disk drive, complete the following steps.
Chapter 6. Removing and replacing components
227