IBM 7383, Инструкция по установке и обслуживанию, Страница: 433 / 488

Table 39. IMM error messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
If an action step is preceded by “(Trained technician only)”, that step must be performed only by a trained
technician.
8107021b-0301ffff Sensor CPU n
QPILinkErr has
transitioned to a less
severe state from
critical. (
n =
microprocessor
number)
Error CPU n QPI link
failure detected. ( n
= microprocessor
number)
1. Check the IBM support website for
an applicable retain tip or firmware
update that applies to this error.
2. Inspect the microprocessor socket
for foreign material, if the
microprocessor socket contains any
foreign material, remove the foreign
material. If it is found damaged,
(trained technician only) replace the
system board (see Removing the
system board and Installing the
system board).
816f0113-0301ffff A bus timeout has
occurred on bus CPU
n PECI. (n =
microprocessor
number) Error This message is for
the use case when
CPU
n PECI bus
access error has
asserted. (
n =
microprocessor
number)
1. (Trained technician only) Replace
microprocessor
n (see Removing a
microprocessor and heat sink and
Installing a microprocessor and heat
sink).
2. If the problem persists and there is
no other CPU with the same error
indication, replace the system
board.
3.
(Trained technician only) Replace
the system board (see Removing the
system board and Installing the
system board).
( n = microprocessor number)
816f0a13-0301ffff A Fatal Bus Error has
occurred on bus CPU
n PECI. (n =
microprocessor
number) Error This message is for
the use case when
CPU
n PECI bus
access error has
asserted. (
n =
microprocessor
number)
1. (Trained technician only) Replace
microprocessor
n (see Removing a
microprocessor and heat sink and
Installing a microprocessor and heat
sink).
2.
If the problem persists and there is
no other CPU with the same error
indication, replace the system
board.
3. (Trained technician only) Replace
the system board (see Removing the
system board and Installing the
system board).
( n = microprocessor number)
Memory errors
Appendix C. Integrated management module II (IMM2) error messages
415