IBM 7383, Инструкция по установке и обслуживанию

Страница: 250 / 488

Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
About this task
To install the DVD drive, complete the following steps.
Procedure
1. Unlock and remove the left-side cover (see “Removing the left-side cover” on
page 39).
2.
Open the bezel (see “Opening the bezel media door” on page 37).
3. Remove the air baffle if installed (see “Removing the air baffle” on page 210).
4. Remove the fan cage assembly (see “Removing the fan cage assembly” on
page 304).
5. Touch the static-protective package that contains the DVD drive to any
unpainted metal surface on the server; then, remove the DVD drive from the
package.
6. Install the blue rails on the DVD drive, using the holes nearest the center of
the drive.
7.
Follow the instructions that come with the drive to set jumpers or switches, if
there is any.
Note: You might find it easier to install the new drive from the front and then
attach the cables.
8. Align the rails on the DVD drive with the guides in the drive bay; then, slide
the DVD drive into the drive bay until the rails click into place.
9. Connect power and signal cables to the drive and the connectors on the
system board (see “Internal cable routing and connectors” on page 186 for
more information).
10. Install the fan cage assembly (see “Installing the fan cage assembly” on page
306).
11. Install the air baffle (see “Installing the air baffle” on page 211).
12.
Close the bezel (see “Closing the bezel media door” on page 185).
232
System x3500 M4 Type 7383: Installation and Service Guide