IBM 7383, Инструкция по установке и обслуживанию

Страница: 333 / 488

9. Push the power paddle card cage assembly into the server till it clicks into
place.
10. Reconnect the internal power cables to the power paddle card cage assembly.
11. Reinstall the fan cage assembly (see “Installing the fan cage assembly” on
page 306).
12. Reinstall the power supplies (see “Installing a hot-swap power supply” on
page 90).
13.
Reinstall the air baffle (see “Installing the air baffle” on page 211).
14. Install and lock the left-side cover (see “Installing the left-side cover” on page
205).
15. Stand the server back up in its vertical position.
What to do next
If you have replaced a component or installed an optional device in the server, you
need to reconnect the power cords and all external cables, and turn on the server
and peripheral devices.
Removing a microprocessor and heat sink
Use this information to remove a microprocessor and heat sink.
Before you begin
Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 34.
If you are replacing a component or installing an optional device in the server, you
need to turn off the server and peripheral devices, and disconnect the power cords
and all external cables.
The following notes describe the type of microprocessor that the server supports
and other information that you must consider when you install a microprocessor
and heat sink:
v
Microprocessors are to be installed only by trained technicians.
Chapter 6. Removing and replacing components
315