IBM 7383, Инструкция по установке и обслуживанию, Страница: 427 / 488

Table 39. IMM error messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
If an action step is preceded by “(Trained technician only)”, that step must be performed only by a trained
technician.
806f0107-0301ffff
806f0107-0302ffff The Processor CPU n
Status has been
detected an
over-temperature
condition. (
n =
microprocessor
number)
Error An over
temperature
condition has
occurred.
1. Make sure that the latest levels of
firmware and device drivers are
installed for all adapters and
standard devices, such as Ethernet,
SCSI, and SAS.
Important:
Some cluster solutions
require specific code levels or
coordinated code updates. If the
device is part of a cluster solution,
verify that the latest level of code is
supported for the cluster solution
before you update the code.
2. Update the firmware (UEFI and
IMM) to the latest level (see
Updating the firmware).
3. Run the DSA program.
4. Reseat the adapter (see Removing
an adapter and Installing an
adapter).
5. Replace the adapter.
6. (Trained technician only) Replace
microprocessor
n (see Removing a
microprocessor and heat sink and
Installing a microprocessor and heat
sink).
7. (Trained technician only) Replace
the system board (see Removing the
system board and Installing the
system board).
( n = microprocessor number)
806f0207-0301ffff
806f0207-0302ffff The Processor CPU n
Status has Failed
with BIST condition.
(
n = microprocessor
number)
Error A processor failed -
BIST condition has
occurred.
1. Make sure that the fans are
operating. There are no obstructions
to the airflow (front and rear of the
server), the air baffles are in place
and correctly installed, and the
server cover is installed and
completely closed.
2. Make sure that the heat sink for
microprocessor
n is installed
correctly.
3. (Trained technician only) Replace
microprocessor
n (see Removing a
microprocessor and heat sink and
Installing a microprocessor and heat
sink).
( n = microprocessor number)
Appendix C. Integrated management module II (IMM2) error messages
409