IBM 7383, Инструкция по установке и обслуживанию

Страница: 435 / 488

Table 39. IMM error messages (continued)
v
Follow the suggested actions in the order in which they are listed in the Action column until the problem is
solved.
v
If an action step is preceded by “(Trained technician only)”, that step must be performed only by a trained
technician.
806f010c-2001ffff
806f010c-2002ffff
806f010c-2003ffff
806f010c-2004ffff
806f010c-2005ffff
806f010c-2006ffff
806f010c-2007ffff
806f010c-2008ffff
806f010c-2009ffff
806f010c-200affff
806f010c-200bffff
806f010c-200cffff
806f010c-200dffff
806f010c-200effff
806f010c-200fffff
806f010c-2010ffff
806f010c-2011ffff
806f010c-2012ffff
806f010c-2013ffff
806f010c-2014ffff
806f010c-2015ffff
806f010c-2016ffff
806f010c-2017ffff
806f010c-2018ffff Memory
uncorrectable error
detected for Memory
DIMM
n Status. ( n =
DIMM number)
Error A memory
uncorrectable error
has occurred.
1. Check the IBM support website for
an applicable retain tip or firmware
update that applies to this memory
error.
2.
Swap the affected DIMMs (as
indicated by the error LEDs on the
system board or the event logs) to a
different memory channel or
microprocessor (see Memory
module installation for memory
population).
3. If the problem follows the DIMM,
replace the failing DIMM (see
Removing a memory module and
Memory module installation).
4. (Trained technician only) If the
problem occurs on the same DIMM
connector, check the DIMM
connector. If the connector contains
any foreign material or is damaged,
replace the system board (see
Removing the system board and
Installing the system board).
5. (Trained technician only) Remove
the affected microprocessor and
check the microprocessor socket
pins for any damaged pins. If a
damage is found, replace the
system board (see Removing the
system board and Installing the
system board).
6. (Trained technician only) Replace
the affected microprocessor (see
Removing a microprocessor and
heat sink and Installing a
microprocessor and heat sink).
Appendix C. Integrated management module II (IMM2) error messages
417