IBM 7383, Инструкция по установке и обслуживанию, Страница: 55 / 488

v
Remove items from your shirt pocket, such as pens and pencils, that could fall
into the server as you lean over it.
v
Avoid dropping any metallic objects, such as paper clips, hairpins, and screws,
into the server.
Handling static-sensitive devices
Use this information to handle static-sensitive devices.
Attention: Static electricity can damage the server and other electronic devices. To
avoid damage, keep static-sensitive devices in their static-protective packages until
you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v
The use of a grounding system is recommended. For example, wear an
electrostatic-discharge wrist strap, if one is available. Always use an
electrostatic-discharge wrist strap or other grounding system when working
inside the server with the power on.
v
Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v
Do not leave the device where others can handle and damage it.
v
While the device is still in its static-protective package, touch it to an unpainted
metal surface on the outside of the server for at least 2 seconds. This drains
static electricity from the package and from your body.
v
Remove the device from its package and install it directly into the server
without setting down the device. If it is necessary to set down the device, put it
back into its static-protective package. Do not place the device on the server
cover or on a metal surface.
v
Take additional care when handling devices during cold weather. Heating
reduces indoor humidity and increases static electricity.
Opening the bezel media door
Use this information to unlock the left-side cover to open or remove the bezel.
Before you begin
Read the safety information in “Safety” on page vii and “Installation guidelines”
on page 34.
About this task
To open the media door, complete the following steps.
Procedure
1.
Check the status of the media door icon. If the icon on the side of the bezel is
in the unlocked position, open the bezel media door directly.
Chapter 2. Installing optional devices
37