Baumuller b maXX BM2500, Руководство по эксплуатации

Страница: 573 / 822

Description of the Software Modules and Parameters
Parameter manual b maXX BM3000
Document no.: 5.12001.07
573
of 820
4
Bit 11 = 0: Method is compatible with b maXX 4400
Control Word Bits 4 (New Set Value) and 5 (Change Set Immediately) are used. The
interpretation of the two control word bits is compatible with b maXX 4400.
Bit 11 = 1: Method according to IEC61800-7-201
Control word bits 4 (New set value), 5 (Change set immediately) and 9 (Change of
set value) are used. The interpretation of these three control word bits corresponds
with IEC 61800-7-201.
m
Bit 12 (Negative directional block) and 13 (Positive directional block)
If one of the two bits is set it will be checked whether the target position to be reached
is located in the blocked direction. If this is the case, a start will not occur and a error
message will be displayed.
If a new target position is to be reached during ongoing positioning, which is located in
the blocked direction, the current target position is started and a error message is dis-
played.
The block check occurs through a comparison of the old target position to the new tar-
get position. The current desired position is meaningless for the test.
118.3
Output position set value
Display of the output position set value in the position target specification in Inc.
118.4
Output speed set value
Display of the output speed set value in the position target specification in Inc/ms.
118.5
Output acceleration set value
Display of the output acceleration set value in the position target specification in Inc/ms².
118.6
Positioning record number actual
This parameter is used to select the current positioning set. Whether it will be started au-
tomatically when changing the active positioning set or a start edge is required in the con-
trol word (
Z
108.1
–
) can be adjusted using Parameter
Z
118.2
–
Mode Bit 10.