Baumuller b maXX BM2500, Руководство по эксплуатации

Страница: 219 / 822

Description of the Software Modules and Parameters
Parameter manual b maXX BM3000
Document no.: 5.12001.07
219
of 820
4
116.4
Target number digital input 1
Number of the parameter to be changed by Digital Input 1.
116.5
Bit selection digital input 1
This parameter specifies which bits of the target parameter will be modified with the bit
pattern Low/High.
If the data of the target parameter is of type Float, no bit selection can be made; all the
bits written to the target parameter will always be of the bit pattern Low or High.
116.6
Set bit pattern for LOW state digital input 1
Bit pattern for logic LOW on Digital Input 1
14 0: Input is edge triggered

1: Input is level triggered
15 0: Input is not inverted

1: Input is inverted
Bit no. Meaning
NOTE!
The following inputs are permanently linked to the "Pulse enable" function: DI4
DI1: Digital input measuring probe 1
DI2: Digital input measuring probe 2
NOTE!
The states of the "Quick stop", "Controller enable" and "Error reset" special functions
can be observed in the "Status digital inputs drive manager"
Z
108.8
–
parameter.
The states of the "Negative hardware limit switch", "Positive hardware limit switch"
and "Zero point reference switch" special functions can be observed in the "Status
limit switch"
Z
121.2
–
parameter.