Baumuller b maXX BM2500, Руководство по эксплуатации

Страница: 255 / 822

Description of the Software Modules and Parameters
Parameter manual b maXX BM3000
Document no.: 5.12001.07
255
of 820
4
The transmission occurs in line with a controller interrupt. The time is set in a grid of con-
troller cycles (62.5 µs).
A setting of 0 controller cycles means that the actual values are transmitted in the inter-
rupt in which the fieldbus task is started in the following. In this way the reading of the set
values follow close upon the transmission of the actual values due to this setting.
131.24
Profinet device name
This parameter contains the Profinet device name (max. 240 characters). ProDrive dis-
plays this parameter as text on the Configuration / Fieldbus slave page, if the fieldbus of
the connected controller is a Profinet type.
131.52
Error counter fieldbus actual values
Error counter for access conflicts at actual values.
The counter is incremented, if the fieldbus firmware did not retrieve the actual values. If
the fieldbus is in operational state and the drive is synchronous with the fieldbus, the error
1937 is set at exceeding of threshold
Z
131.55
–
.
131.53
Error counter fieldbus set values
Error counter for set value failures.
The counter is incremented at every set value failure. If the fieldbus is in operational state
and the drive is synchronous with the fieldbus, the error 1938 is set at exceeding of
threshold
Z
131.56
–
.
131.55
Max error count fieldbus actual values
Error threshold for access conflicts at actual values.
This parameter configures how many access conflicts (actual values have been not re-
trieved) are necessary to set the error 1937.
131.56
Max error count fieldbus set values
Error threshold for set value failures.
This parameter configures how many set value failures (set values have been not written)
are necessary to set the error 1938.