Troubleshooting License File problems
Issue 7 November 2003
B-11
555-233-115
Initialization and periodic checking
When the switch initializes and hourly after that, the system checks all License
File parameters.
shows the error messages that you can encounter as
a result of these periodic checks and the associated License-Error and
No-License modes.
No-License
Outgoing and
incoming calls only
to administered
emergency
numbers.
If you initially login to the SAT if you get a
message that says:
No-License:
xxxxx; Call Processing Blocked
,
the ’xxxx’ tells you why you are in
No-License mode, and no call processing
is allowed. Calls in progress continue but
all new originations are denied.
One of the following conditions is present:
■
No License File is installed in the
system.
■
The License-Error timer expired.
■
A Survivable Remote Processor
detects a port circuit pack in its port
network other than an Expansion
Interface pack.
■
A reset system 3 preserve-license
command has executed and the Offer
Category in translations does not
match the License File.
Clear No-License mode by:
■
correcting the error or mismatch that
caused going into this mode.
■
installing a valid License File that is
consistent with the switch.
Table B-1.
Error messages and repair procedures (Continued)
License Mode
Description
Explanation and repair procedure
Continued on next page
