Xerox DocuPrint 180, Message Manual

Page: 160 / 356

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-82 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS4500 Bad block on input medium. Do one of the following:
Software has encountered an unreadable block.
Action 1. Do one of the following:
* Move -1 blocks to retry read
Enter the MOVE -1 BLOCKS and CONTINUE I commands to
retry same block.
or
* If tape input abort job and clean the drive. Then restart job
Enter the ABORT I command and clean the tape drive. (Refer
to the maintenance chapter in your
Xerox DocuPrint 180 LPS
Operator Guide .)
or
* Space 1 report
Enter the SPACE 1 REPORTS command to skip over the
problem report. Rerun lost data.
or
* ‘CONTINUE I‘ if data loss is acceptable
Enter the CONTINUE I command to resume printing the job.
(Some data will be lost.)
* If problem continues, run another job
2. If the problem continues, recreate the job.
OS4520 Input attempting recovery...tape not ready.
A software failure has caused a system rollover and automatic job
recovery has been initiated. The system is unable to rewind the tape
because the tape drive is not online to the printer; or no tape has
been mounted.
Action 1. If the drive is offline, press the Online button on the tape drive.
2. Mount tape if necessary. (Refer to the offline chapter in your
Xerox DocuPrint 180 LPS Operator Guide .)
OS4650 Input has recovered to page boundary.
Automatic job recovery has been initiated after a system rollover.
Input has moved back to the beginning of the page at which the
software failure occurred.
Action Follow instructions on the printer control console display and wait for
printing to resume and complete.