Xerox DocuPrint 180, Message Manual

Page: 148 / 356

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-70 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS2922 Enter the TOTAL number of sets to create:
This is one of a series of prompts for information to develop the FEX
test case. This message is followed by messages OS2923, OS2924,
OS2008, and OS1136.
Action Enter the number of sets you want printed for the FEX test job.
OS2923 Enter the number of pages per set:
This is one of a series of commands which asks you for information
to develop the FEX test case. Related messages are OS2922,
OS2924, OS2008, and OS1136.
Action Enter the number of pages for each set of the FEX test case job.
OS2924 Enter the FRM name (leave off the .FRM)
This is one of a series of prompts for information to develop the FEX
test case. Related messages are OS2922, OS2923, OS2008, and
OS1136.
Action Enter the form name (without the directory or file-type name) you
wish to use for the FEX test job.
OS2950 Software timing problem has caused a printer cycle-down
Input is being processed too rapidly for output to print. Output has
stopped.
Action Enter the CONTINUE O command to resume printing.
OS2960 Back up host to start of report or nn pages, whichever is less
The system is in a recovery mode after a software failure.
Action Resend either the number of pages stated or the entire report that
was printing at the time of the failure.
OS2980 Function not available in this LOGON class
The usage of the entered command was restricted at installation by
an RCU (Restrict Command Usage) command.
Action Obtain the correct password and log on at the required level. (Refer
to your
Xerox DocuPrint 180 LPS Operations Reference chapter on
setting LPS parameters for additional information.)
OS2990 Use ‘PROBLEM’ at earliest opportunity.
The system has detected a hardware problem. (This message
occurs in conjunction with other messages describing problem.)
Printing can continue. However, if the condition is not corrected,
printing may stop eventually.
Action 1. Enter the PROBLEM command and record SAN codes
appearing on the display.
2. Contact your systems specialist or Xerox Customer Service.