Xerox DocuPrint 180, Message Manual

Page: 144 / 356

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-66 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS2750 Job not found. Check and retry.
The job id number entered in the START command was not sent.
Action 1. Verify that the job number was entered correctly.
2. Reenter the START command.
3. If the message reappears, resend the job.
OS2760 Sample file not found. Check and reenter.
The SAMPLE command was entered, but the file name requested for
sampling is not in the system.
Action 1. Verify the file name and reenter the SAMPLE command
correctly.
2. If the message reappears, load the desired file to the system
disk. (Refer to your Xerox DocuPrint 180 LPS Operations
Reference chapter on managing LPS resources for additional
information.)
OS2800 Move or space function complete.
The system has completed spacing over information on magnetic
tape as requested.
Action Enter the CONTINUE I command if the place where input is resuming
has the same JDE and JDL as before SPACE command was
entered.
or
If JDE/JDL are different than before the spacing function, enter the
CONTINUE command followed by a new JDE and JDL ID (CON
“jde,” “jdl”). (Refer to the offline chapter in your
Xerox DocuPrint 180
LPS Operator Guide .)
OS2810 Start-up message from Job Tape follows:
This message appears in a single report mode. A report delimiter or
forms information message will be displayed next.
Action Watch the printer control console display for a forthcoming
information message.
OS2811 The following is a document-generated “jobstart” message:
This is an informational message displayed prior to printing the job.
The actual “jobstart” message will follow.
Action None.
OS2812 The following is a document-generated “jobend” message:
This is an informational message displayed after the job has been
printed. The actual “jobEnd” message will follow.
Action None.