Xerox DocuPrint 180, Message Manual

Page: 298 / 356

XEROX DOCUPRINT 180 LPS ADDITIONAL MESSAGES
15-32 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
Command sequence error, record number not equal to last +1.
One or more of the report definition commands are out of order.
Action If the problem persists, call Xerox Customer Service.
Communication with the Printer is established
TBD
Action Low-level communication between the system controller and the
printer has been established. The system will now attempt to initialize
Client-Layer communication.
Completed reports not finished transferring from In-Process
Log.
Exit to DOS has been erroneously enabled and selected. No loss of
data should occur as the transfer process will continue when the PC
UI session is restarted.
Action If the problem persists, call Xerox Customer Service.
Corrupt Master Directory file.
The record manager has detected an error while reading the Master
Directory file for a list of Audit Logs.
Action If the problem persists, call Xerox Customer Service.
Corrupt report definition file.
A corrupt report definition file has been detected. Audit Log display
or printing may be incomplete.
Action If the problem persists, call Xerox Customer Service.
Disk full inserting record in audit log.
The disk drive reserved for audit logs is full. Audit data for the report
being printed may be lost until audit log files are deleted.
Action Delete one or more audit logs using the window provided when the
error occurs. This error can be avoided by deleting audit logs when
the window warning of a disk approaching full is displayed.
Do you want to retry Client-Layer Initialization? (Type ‘Y’ for
Yes, or ‘N’ for No; ENTER = Yes)
A ‘Yes’ answer tells the system controller to try again to establish full
communication with the printer.
If you answer ‘No,’ the system controller will not try to reestablish full
communication with the printer. Without full communication with the
printer, you can still use the system controller utilities, such as the
Editor, but you cannot print.
Action Enter PSC in the command line message window when you wish to
attempt reconnection with the printer.