Xerox DocuPrint 180, Message Manual

Page: 273 / 356

XEROX DOCUPRINT 180 LPS ADDITIONAL MESSAGES
XEROX DOCUPRINT 180 LPS MESSAGE GUIDE 15-7
567 Parity error while receiving
The user interface does not use this feature of RS232.
Action Select the OK header button to retry the process. If the problem
persists, call Xerox Customer Service.
568 Transmit queue full
The communication driver’s transmit queue is full.
Action Select the OK header button to retry the process. If the problem
persists, call Xerox Customer Service.
569 Can’t kill Terminal Emulation Mode timer
The TEM (terminal emulation mode) timer is not active or cannot be
turned off. Probably the result of an internal PC user interface error.
Action Select the OK header button to retry the process. If the problem
persists, call Xerox Customer Service.
570 Invalid ESS signal ID
The system controller signal indicator is out of range. May mean
outdated PC user interface software or a protocol error.
Action Select the OK header button to retry the process. If the problem
persists, call Xerox Customer Service.
571 Invalid Acknowledge parameter
The system controller transmitted a character that is invalid in the
current context. It can only be ACK, NACK, or start-of-packet.
Action Select the OK header button to retry the process. If the problem
persists, call Xerox Customer Service.
572 Can’t send SM_OBJ message
The message used to notify the system of incoming system controller
data could not be placed on the PC user interface message queue.
Action Select the OK header button to retry the process. If the problem
persists, call Xerox Customer Service.
573 Invalid paper status update
The contents of the PAPER signal is not valid.
Action Select the OK header button to retry the process. If the problem
persists, call Xerox Customer Service.