Xerox DocuPrint 180, Message Manual

Page: 240 / 356

SYSTEM VERIFICATION ERROR MESSAGES
13-2 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
FCG starting. Version x
FCG is starting with the parameters (or version) indicated.
Action 1. Retry the FCG command.
2. If the message reappears, look for other system or printer
messages to explain the condition.
3. If no other explanatory messages appear, contact your
supervisor or systems specialist.
FCG exiting: failure to connect to the IOT.
The FCG utility is unable to communicate with the printer. There may
be a print job or another system task being processed.
Action 1. Retry the FCG command.
2. If the message reappears, look for other system or printer
messages to explain the condition.
3. If no other explanatory messages appear, contact your
supervisor or systems specialist.
FCG exiting: data value out of range.
FCG checks to see that all the data values specified in your
command are within allowable ranges before it updates the printer‘s
non-volatile memory (NVM). The system displays this message if
values are out of range.
Action None.
Note: The percentage of wire left on the spool parameter must be
between 0 and 100 percent. A value greater than 100, for example,
would be out of range.
Font memory missing: Bank(s) xx, xy, xz, ...
Some banks of font memory are missing or have had data loss.
Banks are numbered 1 through 4, and each are 4 megabits in length.
Action None
Graphics memory missing: Bank(s) xx, xy, xz, ..
Some, but not all, banks of graphics memory appear to be missing or
have failed testing. Banks are displayed in 16K sections.
Action None.
Main memory missing: Bank(s) xx, xx, xy, xz, ...
Message appears if any memory specified during the system
configuration phase is either not present or has had data loss. Banks
are displayed in 16K sections.
Action None.