Xerox DocuPrint 180, Message Manual

Page: 117 / 356

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 180 LPS MESSAGE GUIDE 6-39
OS1927 This system does not support Ethernet processing
The command entered applies only to Ethernet. The system is not
equipped with the Ethernet Controller Option for operating on the
network.
Action None.
OS1928 Complex page encountered. System adjusting performance.
A page has been encountered that cannot be formatted for print in
the normally allowed time. The system will dead cycle without
feeding paper until formatting is complete. The page will print but
system throughput performance will be degraded.
Action None.
OS1930 System not configured for selected process.
The system does not contain hardware needed to perform the
requested task.
Action None.
OS1950 FCB received contained no channel assignments.
The Forms Control Buffer (FCB) sent from the host was not coded
correctly; channels were not specified telling which data should be
printed on which line.
Action Retransmit the FCB with channel assignments. (Refer to your Xerox
DocuPrint 180 LPS Operations Reference for additional information.)
OS1959 Partial set delivered to bin before switch occurred.
An incomplete set of printed output was sent to the current bin before
the system could complete your request to change to another bin.
Action Check and discard, if incomplete, the set delivered to the first bin.
OS1960 Print quality adjustment will cause partial set ejection.
This message is displayed if print quality adjustment will cause a
partial set to be ejected from the finishing module‘s compiler tray.
Action None.
OS1961 Simplex feeding from tray 2 may cause incomplete print quality
adjustment.
Tray 2 does not have adequate capacity to perform a simplex mode
print quality adjustment (PQA) under certain conditions.
Action Select a different paper tray from which to feed your simplex print job.