Xerox DocuPrint 180, Message Manual

Page: 90 / 356

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-12 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS1010 Starting job xxxx
The system is initiating processing for the indicated job.
Action None.
OS1011 Starting diagnostic print job
The system diagnostic interface (SDI) task is involved.
Action None.
OS1012 ALUN$ failed command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action None.
OS1013 Device offline, command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action None.
OS1014 Output cannot be switched--Selected Tray is full
The SELECT or SEPARATE command was entered while the printer
was printing. Output cannot be switched because the entered stacker
tray is full.
The printer control console displays:
OUTPUT TRAY CANNOT BE SWITCHED--SELECTED TRAY IS
FULL
Action 1. Press the <STOP> key or the Stop button on the printer to halt
printing.
2. Unload the full stacker tray.
3. Press the <CON> key to resume printing.
4. Reenter the SELECT or SEPARATE command.
OS1015 ALDN$ failed, command ignored
The device substitution specified in the SUB DEV command has
failed. Check command and retry.
Action None.
OS1016 NT01 or staple not supported
Xerox DocuPrint 180 LPS does not support Staple. If Staple is
specified in a JDE, JDL or DJDE, then INPUT will ignore it.
Action None.