Xerox DocuPrint 180, Message Manual

Page: 142 / 356

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-64 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS2712 Command not allowed while task is running.
The command entered cannot be processed while the current task is
ongoing.
Action 1. Abort the current task or wait until it is completed.
2. Reenter the desired command.
OS2713 This command is no longer supported. See -11
The command entered is obsolete; your system cannot respond.
Action 1. Refer to your Xerox DocuPrint 180 LPS OSS Program
Description (“-11”) for the correct command for the desired
process.
2. If information cannot be located, contact your systems
specialist or Xerox Customer Support.
OS2714 Unable to obtain status at this time. Retry
The PRNTRSTATUS or JOBS command cannot be honored at this
time. The PRNTRSTATUS command will not be honored while
output is establishing communications. The JOBS command may not
be honored if either input or output is performing a report transition or
is near the end of the job.
Action Retry.
OS2715 Command ignored, retry later.
The command entered cannot be processed because it conflicts with
an ongoing process.
Action Reenter the command after the process is completed.
OS2720 Invalid control key. Retry
The system cannot respond at this time to the function key that was
pressed due to a conflicting process or condition of the printer.
Action Wait until the process has completed and press the key again.
or
Press a different function key.
OS2725 Invalid drive unit specified.
The specified command refers to an invalid disk drive unit.
Action Check and retry command.
OS2726 Invalid tape device specified.
You have named a tape device that is not available on your system.
Action Verify the tape device number and retry the command.