Xerox DocuPrint 180, Message Manual

Page: 185 / 356

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
XEROX DOCUPRINT 180 LPS MESSAGE GUIDE 6-107
OS Level 7: System problem
Indicates a problem with a specific job. Run the next job and report
the problem to your supervisor.
OS7100 PCC or translate table unreadable.
The system cannot read the printer carriage control (PCC) or
translate the table statement because it is incorrectly formatted. The
job will abort.
Action 1. Reenter the statement correctly in JDL. (Refer to your Xerox
DocuPrint 180 LPS PDL Reference or Xerox DocuPrint 180
LPS Operations Reference chapter on setting LPS parameters
for additional information.)
2. Restart the job.
OS7110 CME file not found.
OS7120 PDE file not found.
OS7130 Font File not found.
OS7140 Form File not found.
OS7150 Form Font not found.
A file of the type indicated in the message was called for by JDE or
DJDE, but does not exist on the system disk. (The name of the file is
displayed in the previous message.) The job will abort.
Action 1. Load the desired file onto the system disk. If its name is listed in
the file directory, reload and replace it. (Refer to your Xerox
DocuPrint 180 LPS Operations Reference
chapter on
managing LPS resources for additional information.)
2. Restart the job.
OS7160 Unable to read stockset file from disk.
An unspecified error occurred while attempting to read a STOCKSET
file.
Action Contact your systems specialist or Xerox Customer Support.
OS7170 Translation file content is improper.
When the system was sysgened for a language other than English,
the translation file which interprets commands proved to be
defective.
Action Contact your systems specialist or Xerox Customer Support.
OS7190 Problem with file=====> xxxx.
This message precedes messages OS7110 - OS7150. It indicates
which file the system was unable to locate on disk. The job will abort.
Action See the recommended action for messages OS7110-OS7150.