Xerox DocuPrint 180, Message Manual

Page: 36 / 356

HIP (HOST INTERFACE PROCESSOR) MESSAGES
4-14 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
HP2500 Change of job xxxx to file file-type failed: unrecoverable I/O
error yy.
The CHANGE command failed due to the error values specified in
this message. These error values will be one of the following:
•
03disk controller failed
•
04disk parity errors
•
10end of file detected
•
24device full (insufficient space for the file)
•
26no such file
•
32input file read error
•
56output file write error
•
59disk device fault (unable to perform operation)
All of the values listed above except 24 will generate an error log
entry.
Action If value 24 is received, your company’s analyst/programmer should
free up sufficient contiguous system disk space by either deleting
unnecessary files or compressing the disk.
Note: Compressing the disk where the HIPBF.SYS resides should
not be performed because the HIP files will become inaccessible.
HP5000 Host restarted. Trying to reestablish communications
The link to the DMR host was broken and is now reestablished. HIP
is attempting to reestablish communications with the host and
resume from the point where the link was broken.
Action None.
HP7100 Can not change hosts while jobs are pending or active
Hosts cannot be changed until all jobs are completed.
Action 1. Enter the appropriate HIPHOST command to change hosts.
2. Wait until active and pending jobs have been printed.
HP8100 HIP dynamic memory allocation failure: reload
HIP does not have enough memory to continue.
Action 1. Enter the HIP END command.
2. Restart HIP or reboot the system.