Xerox DocuPrint 180, Message Manual

Page: 96 / 356

OSS (OPERATING SYSTEM SOFTWARE) MESSAGES
6-18 XEROX DOCUPRINT 180 LPS MESSAGE GUIDE
OS1195 Undefined ink: color
The ink you specified (represented by the word color in the message
shown) is incorrect.
Action 1. Check to make sure that the ink name is entered correctly.
2. If the message reappears, consult your systems specialist.
OS1200 Command not allowed while HIP or SDI active
The system is unable to respond to the entered command while the
printer is in communication with the host interface processor.
Action 1. Terminate connection with HIP. (Refer to the HIP chapter in
your
Xerox DocuPrint 180 LPS Operator Guide
.)
2. Reenter the desired command.
OS1215 Input stopped after orderly shutdown
A software failure has caused a system rollover. Data being input has
stopped processing while the system attempts to reestablish the
correct state at the time of failure in an effort to recover all data.
Action Follow directions appearing at the system controller display to initiate
automatic job recovery and abort the analysis dump. (Refer to the
offline chapter in your
Xerox DocuPrint 180 LPS Operator Guide .)
OS1225 Automatic recovery initiated
Automatic job recovery has been initiated at the system controller
display after a system rollover due to software failure.
Action Follow directions appearing at the system controller display to
complete the recovery process.
OS1230 Separate not permitted with destination configuration
This is a response to SEPARATE ON or SEPARATE OFF when a
two-tray stacker is not present.
Action None.
OS1235 CLP Commands not allowed while printing
A CLP command was entered. CLP commands may not be used
while the printer is active.
Action None.