Siemens SINAMICS S150 NEMA, Operating Instructions Manual

Page: 295 / 862

Operation
6.6 Control via the operator panel
Enclosed Drives
Operating Instructions, 12/2018, A5E36652151A
293
6.6.2 Menu: Operation screen
Description
The operation screen displays the most important status variables for the drive unit:
In the delivery condition, it displays the operating state of the drive, the direction of rotation,
the time, as well as four drive variables (parameters) numerically and two in the form of a bar
display for continuous monitoring.
There are two ways to reach the operation screen:
1.
After the power supply has been switched on and the system has ramped up.
2. By pressing the MENU key and F5 "OK "
Figure 6-17 Operation screen
If a fault occurs, the system automatically displays the fault screen (see "Faults and alarms").
In LOCAL control mode, you can choose to enter the setpoint numerically (F2: setpoint).
With F3 "Extras", screen2 and CDS data set (see section CDS setting via AOP (Page 313))
can be selected.
The individual parameters of the operation screen can be selected using F4 "Sel. par." The
corresponding parameter number of the short identifier is displayed using F1 "Help+" and a
description of the parameter can be called up.
Settings
When you choose Commissioning / service –> AOP settings –> Define operation screen, you
can adjust the display type and the values displayed as required (see "AOP settings").