Siemens SINAMICS S150 NEMA, Operating Instructions Manual

Page: 336 / 862

Operation
6.7 Communication according to PROFIdrive
Enclosed Drives
334
Operating Instructions, 12/2018, A5E36652151A
Error
value
Meaning Comment Additional
info
0x7A Parameter %s [%s]: Write access
only in the commissioning state, data
record base configuration
(device: p0009 = 4).
– –
0x7B Parameter %s [%s]: Write access
only in the commissioning state,
device configuration
(device: p0009 = 1).
– –
0x7C Parameter %s [%s]: Write access
only in the commissioning state,
device download
(device: p0009 = 29).
– –
0x7D Parameter %s [%s]: Write access
only in the commissioning state,
device parameter reset
(device: p0009 = 30).
– –
0x7E Parameter %s [%s]: Write access
only in the commissioning state,
device ready (device: p0009 = 0).
– –
0x7F Parameter %s [%s]: Write access
only in the commissioning state,
device (device: p0009 not equal to 0).
– –
0x81 Parameter %s [%s] must not be
written during download.
– –
0x82 Transfer of master control is blocked
by BI: p0806.
– –
0x83 Parameter %s [%s]: Requested BICO
interconnection not possible.
BICO output does not supply float values, however the
BICO input requires float values.
–
0x84 Parameter %s [%s]: Parameter
change inhibited
(refer to p0300, p0400, p0922)
– –
0x85 Parameter %s [%s]: Access method
not defined.
– –
0x87 Write job will not be executed. The write job is rejected because know-how protection is
active.
–
0xC8 Below currently valid limit. Modification request for a value that, although within
"absolute" limits, is below the currently valid lower limit.
–
0xC9 Above currently valid limit. Modification request for a value that, although within
"absolute" limits, is above the currently valid upper limit
(e.g., specified by the actual converter rating).
–
0xCC Write access not permitted. Write access is not permitted because an access code is
not available.
–