Rohde & Schwarz FPL1000 Series, User Manual

Page: 841 / 899

Remote Commands
R&S
®
FPL1000
841 User Manual 1178.3370.02 ─ 03
●
"STATus:OPERation Register" on page 188
●
"STATus:QUEStionable:ACPLimit Register" on page 190
●
"STATus:QUEStionable:EXTended Register" on page 191
●
"STATus:QUEStionable:FREQuency Register" on page 192
●
"STATus:QUEStionable:LIMit Register" on page 193
●
"STATus:QUEStionable:LMARgin Register" on page 193
●
"STATus:QUEStionable:POWer Register" on page 194
●
"STATus:QUEStionable:TIMe Register" on page 195
● General Status Register Commands .................................................................... 841
● Reading Out the CONDition Part .......................................................................... 842
● Reading Out the EVENt Part .................................................................................842
● Controlling the ENABle Part ..................................................................................843
● Controlling the Negative Transition Part ............................................................... 843
● Controlling the Positive Transition Part .................................................................844
● Service Request ....................................................................................................845
8.11.1 General Status Register Commands
STATus:PRESet
............................................................................................................ 841
STATus:QUEue[:NEXT]?
................................................................................................841
STATus:PRESet
This command resets the edge detectors and
ENABle
parts of all registers to a defined
value. All
PTRansition
parts are set to
FFFFh
, i.e. all transitions from 0 to 1 are
detected. All
NTRansition
parts are set to 0, i.e. a transition from 1 to 0 in a
CONDition
bit is not detected. The
ENABle
part of the
STATus:OPERation
and
STATus:QUEStionable
registers are set to 0, i.e. all events in these registers are not
passed on.
Usage: Event
STATus:QUEue[:NEXT]?
This command queries the most recent error queue entry and deletes it.
Positive error numbers indicate device-specific errors, negative error numbers are error
messages defined by SCPI. If the error queue is empty, the error number 0, "No error",
is returned.
This command is identical to the
SYSTem:ERRor[:NEXT]?
command.
Usage: Query only
Using the Status Register