Rohde & Schwarz FPL1000 Series, User Manual

Page: 468 / 899

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
468 User Manual 1178.3370.02 ─ 03
For details see "Mapping Samples to sweep Points with the Trace Detector"
on page 460.
"Auto" Selects the optimum detector for the selected trace and filter mode.
This is the default setting.
"Type" Defines the selected detector type.
Remote command:
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion]
on page 692
[SENSe:][WINDow<n>:]DETector<t>[:FUNCtion]:AUTO
on page 692
Hold
If activated, traces in "Min Hold" , "Max Hold" and "Average" mode are not reset after
specific parameter changes have been made.
Normally, the measurement is started again after parameter changes, before the mea-
surement results are analyzed (e.g. using a marker). In all cases that require a new
measurement after parameter changes, the trace is reset automatically to avoid false
results (e.g. with span changes). For applications that require no reset after parameter
changes, the automatic reset can be switched off.
The default setting is off.
Remote command:
DISPlay[:WINDow<n>]:TRACe<t>:MODE:HCONtinuous
on page 689
Smoothing
If enabled, the trace is smoothed by the specified value (between 1 % and 50 %). The
smoothing value is defined as a percentage of the display width. The larger the
smoothing value, the greater the smoothing effect.
Note: Effects of smoothing on post-processing functions. Note that in Spectrum mode,
all functions performed after the sweep, such as limit checks, markers, or channel
power measurements, are based on the smoothed trace data. Thus, the results will dif-
fer from results based on the original trace.
For more information see
"Trace Smoothing" on page 465.
Remote command:
DISPlay[:WINDow<n>]:TRACe<t>:SMOothing[:STATe]
on page 690
DISPlay[:WINDow<n>]:TRACe<t>:SMOothing:APERture
on page 690
Average Mode
Defines the mode with which the trace is averaged over several sweeps.
This setting is generally applicable if trace mode "Average" is selected. For FFT
sweeps, the setting also affects the VBW (regardless of whether or not the trace is
averaged).
(See also "Video Bandwidth (VBW)" on page 260).
How many sweeps are averaged is defined by the " Sweep/Average Count "
on page 399.
For details see "How Trace Data is Averaged - the Averaging Mode" on page 464.
Trace Configuration