![Rohde & Schwarz FPL1000 Series User Manual Download Page 141](http://html.mh-extra.com/html/rohde-and-schwarz/fpl1000-series/fpl1000-series_user-manual_1477826141.webp)
Common Instrument Functions
R&S
®
FPL1000
141
User Manual 1178.3370.02 ─ 03
automatically, and a message box informs you about the process. When the recon-
figuration has finished, the instrument again reboots automatically.
Note:
Do not switch off the instrument during the reconfiguration process!
Now the firmware update is complete.
It is recommended that you perform a self-alignment after the update (see
ter 6.3.7.4, "How to Align the Instrument"
6.3.4.5
General Configuration Settings
Access
: SETUP > "System Configuration" > "Config"
General system settings, for example concerning the initial behaviour of the
R&S
FPL1000 after booting, can also be configured.
...................................................................................... 141
Preset Mode
The presettings can be defined in the "Config" tab of the "System Configuration" dialog
box.
"SAN"
Signal and Spectrum Analyzer mode
Remote command:
Out-of-range value behavior
By default, if you enter a value that is outside the valid range in an input field for a set-
ting, a warning is displayed and the value is not accepted. Alternatively, entries below
the minimum value can automatically be set to the minimum possible entry, and entries
above the maximum value set to the maximum possible entry. This behavior avoids
errors and facilitates setting correct values.
6.3.4.6
Additional Interfaces
The following settings are only available if the "Additional interfaces" option R&S
FPL1-
B5 is installed.
General Instrument Setup