Rohde & Schwarz FPL1000 Series, User Manual

Page: 481 / 899

The Spectrum Application (RF Measurements)
R&S
®
FPL1000
481 User Manual 1178.3370.02 ─ 03
Furthermore, the RUN CONT key controls the Sequencer, not individual sweeps. RUN
CONT starts the Sequencer in continuous mode.
For details on the Sequencer, see
Chapter 5.4.1, "The Sequencer Concept" ,
on page 85.
Remote command:
INITiate<n>:CONTinuous
on page 536
Single Sweep / Run Single
After triggering, starts the number of sweeps set in "Sweep Count". The measurement
stops after the defined number of sweeps has been performed.
While the measurement is running, the "Single Sweep" softkey and the RUN SINGLE
key are highlighted. The running measurement can be aborted by selecting the high-
lighted softkey or key again.
Note: Sequencer. If the Sequencer is active, the "Single Sweep" softkey only controls
the sweep mode for the currently selected channel setup. However, the sweep mode
only takes effect the next time the Sequencer activates that channel setup, and only for
a channel-defined sequence. In this case, the Sequencer sweeps a channel setup in
single sweep mode only once.
Furthermore, the RUN SINGLE key controls the Sequencer, not individual sweeps.
RUN SINGLE starts the Sequencer in single mode.
If the Sequencer is off, only the evaluation for the currently displayed channel setup is
updated.
For details on the Sequencer, see
Chapter 5.4.1, "The Sequencer Concept" ,
on page 85.
Remote command:
INITiate<n>[:IMMediate]
on page 536
Clear Spectrogram
Resets the spectrogram result display and clears the history buffer.
This function is only available if a spectrogram is selected.
Remote command:
CALCulate<n>:SPECtrogram:CLEar[:IMMediate]
on page 694
Color Map Settings
Access : "Overview" > "Analysis" > "Traces" > "Spectrogram" > "Color Mapping"
or : TRACE > "Spectrogram Config" > "Color Mapping"
For more information on color maps see "Color Maps" on page 475. For details on
changing color mapping settings see "How to Configure the Color Mapping"
on page 484.
In addition to the available color settings, the dialog box displays the current color map
and provides a preview of the display with the current settings.
Trace Configuration