Rohde & Schwarz FPL1000 Series, User Manual

Page: 714 / 899

Remote Commands
R&S
®
FPL1000
714 User Manual 1178.3370.02 ─ 03
Example: CALC:MARK3:TRAC 2
Assigns marker 3 to trace 2.
Manual operation: See " Assigning the Marker to a Trace " on page 427
CALCulate<n>:MARKer<m>:X <Position>
This command moves a marker to a particular coordinate on the x-axis.
If necessary, the command activates the marker.
If the marker has been used as a delta marker, the command turns it into a normal
marker.
Suffix:
<m>
.
Marker (query: 1 to 16)
<n> Window
Parameters:
<Position> Numeric value that defines the marker position on the x-axis.
The unit is either Hz (frequency domain) or s (time domain) or
dB (statistics).
Range:
The range depends on the current x-axis range.
Example: CALC:MARK2:X 1.7MHz
Positions marker 2 to frequency 1.7 MHz.
Manual operation: See " Marker Table " on page 254
See " Marker Peak List " on page 254
See " Marker 1 / Marker 2 / Marker 3 / Marker 4 " on page 357
See " Marker 1 / Marker 2 / Marker 3 " on page 361
See "Marker Position X-value " on page 426
8.8.8.2 General Marker Settings
The following commands control general marker functionality.
Remote commands exclusive to general marker functionality
DISPlay[:WINDow<n>]:MTABle
....................................................................................... 714
DISPlay:MINFo[:STATe]
................................................................................................. 715
CALCulate<n>:MARKer<m>:X:SSIZe
.............................................................................. 715
DISPlay[:WINDow<n>]:MTABle <DisplayMode>
This command turns the marker table on and off.
Suffix:
<n>
.
irrelevant
Setting Basic Spectrum RF Measurement Parameters